01 of 08
Introduction and MaterialsThis knot is a little more advanced than basic knots such as the square knot. It has a variety of applications such as finishing off the ends of a macrame necklace which you can then pull over your head.
You will need at least two strands of your choice of cord such as hemp, waxed linen, or rat tail.Continue to 2 of 8 below.
02 of 08
Form a Loop1. Take one side, form it into a loop, and set the loop on top of the other cord (pictured in red). From now on, you only need to move the red cord.Continue to 3 of 8 below.
03 of 08
Cord Goes Up and Over2. Now take the red cord and bring it up and over the first end (bottom) of the looped cord.Continue to 4 of 8 below.
04 of 08
Cord Goes Up and Under3. Continue to move the red cord up and bring it under the second end (top).Continue to 5 of 8 below.
05 of 08
Cord Goes Down and Over4. Now bring the red cord down and over the looped cord.Continue to 6 of 8 below.
06 of 08
Cord Crosses Under5. Continue to move the red cord down so it crossed under itself (notice you’re forming a loop with the red cord now.)Continue to 7 of 8 below.
07 of 08
Cord Goes Over Again6. Then bring the red cord over the looped cord. You should have a loop inside a loop.Continue to 8 of 8 below.
08 of 08
Pull Cords Tight7. Pull both cords with an even tension to form your Josephine Knot.