01 of 08
How to Make an Easy Origami Christmas Tree Card!
Learn how to make a wonderful origami Christmas tree card! A handmade Christmas card is the perfect finishing touch to your gifts this Christmas!
This super simple origami Christmas tree is made using 4 sheets of small square paper.
You will need a few dabs of glue to complete the finished Christmas tree card!
The sizes used for the card in the photo are 7.5 x 7.5 cm thin card.
You can use any kind of paper you have around the house.
Fancy a more complicated origami tree? If you're up for a challenge, check out this advanced origami Christmas tree by Paper Kawaii on youtube.Continue to 2 of 8 below.
02 of 08
Starting white side up (if you have one)!
Fold the paper in half diagonally both ways.
Flip the paper over to the other (colored) side and rotate.
Fold the paper in half and unfold.Continue to 3 of 8 below.
03 of 08
Make the Pieces of the Tree
Flip the paper back over to the other side.
Push the right and left sides into the middle, collapsing the top section down.
You now have a water bomb base.
Make 2 more of these!Continue to 4 of 8 below.
04 of 08
Make the Tree Trunk
Now it's time to make the trunk of the origami Christmas tree.
Start white side up (if you have one).
Fold the paper in half both ways and unfold.
Flip the paper to the other side.
Fold the bottom right corner up to the top left corner.
Unfold.Continue to 5 of 8 below.
05 of 08
Continue Folding the Trunk
Rotate the paper and flip it over to the other side.
Push in the right and left corners to the middle.
This is an origami square base.
Fold the right and left corners to the middle.
Fold the bottom corner up to the middle and unfold.
Repeat on the back.Continue to 6 of 8 below.
06 of 08
Complete the Tree Trunk
Flip the 'pages' of the model to the opposing sections and fold the bottom sections up, and unfold.
Unfold the whole thing. (to the white side).
Fold the corners in.
Re-fold the trunk.
Re-tuck the sides in and flatten it out.Continue to 7 of 8 below.
07 of 08
Glue the Tree Together
Now it's time to stick the tree together with a bit of glue.
Glue the top of one of the tree sections.
Get another tree section and slot it on top, gluing it at the same time.
You can adjust the height of the tree by pushing it on further.
Do the same with the tree trunk.Continue to 8 of 8 below.
08 of 08
Attach the Tree to a Card
Now you can stick the tree onto a piece of card that is folded in half.
Leave the tree as it is or make it more three dimensional by folding the right and left sections in the opposite directions.
You can also decorate the tree by drawing baubles and tinsel with pens or sticking other decorations on top!